Configuring SNMP & RMON Configuration Example
Configuration Guide
731
6.3 Network Topology
As shown in the following figure, the NMS host with IP address 172.168.1.222 is connected
to the core switch, Switch B. On Switch A, ports 1/0/1 and 1/0/2 are monitored by the NMS;
port 1/0/3 is connected to Switch B. And port 1/0/3 and the NMS are able to reach one
another.
Figure 6-1 Network Topology
Gi1/0/1
NMS
Switch B
Switch A
IP: 172.168.1.222
Gi1/0/2
Gi1/0/3
Demonstrated with T1600G-28TS, this chapter provides configuration procedures in two
ways: using the GUI and using the CLI.
6.4 Using the GUI

Configuring Rate Limit on ports
Configure the rate limit on required ports. For detailed configuration, please refer to
Configuring QoS
.

Configuring SNMP
1) Choose SNMP > SNMP Config > Global Config to load the following page. Enable
SNMP, and set the Remote Engine ID as 123456789a. Click Apply.
To Next Page
Loading...
Need help?
General