Configuration Guide 196
Configuring Protocol VLAN Configuration Example
Switch_2(config-if)#exit
Switch_2(config)#interface gigabitEthernet 1/0/3
Switch_2(config-if)#switchport general allowed vlan 20 untagged
Switch_2(config-if)#exit
4) Create the IPv6 protocol template.
Switch_2(config)#protocol-vlan template name IPv6 frame ether_2 ether-type 86dd
Switch_2(config)#show protocol-vlan template
Index Protocol Name Protocol Type
---- ----------------- ------------------------------------
1 IP EthernetII ether-type 0800
2 ARP EthernetII ether-type 0806
3 RARP EthernetII ether-type 8035
4 IPX SNAP ether-type 8137
5 AT SNAP ether-type 809b
6 IPv6 Ethernet II ether-type 86dd
5) Configure the protocol groups.
Switch_2(config)#protocol-vlan vlan 10 template 1
Switch_2(config)#protocol-vlan vlan 20 template 6
6) Add port 1/0/1 to the protocol groups.
Switch_2(config)#show protocol-vlan vlan
Index Protocol-Name VID Member
---- --------------- ------- -------------
1 IP 10
2 IPv6 20
Switch_2(config)#interface gigabitEthernet 1/0/1
Switch_2(config-if)#protocol-vlan group 1
Switch_2(config-if)#protocol-vlan group 2
Switch_2(config-if)#exit
Switch_2(config)#end
Switch_2#copy running-config startup-config
To Next Page
Loading...
