TP-Link T1600G-52PS User Manual

Configuration Guide 450
Configuring QoS Bandwidth Control Configuration
Broadcast
Rate Mode /
Broadcast
To enable the broadcast rate control, select a broadcast rate mode and specify
the upper rate limit for receiving broadcast packets in the Broadcast field. The
packet traffic exceeding the rate will be discarded.
The switch supports the following three rate modes:
kbps: Specify the upper rate limit in kilo-bits per second, which ranges from 1 to
1000000 kbps. This mode is invalid if PPS is enabled.
ratio: Specify the upper rate limit as a percentage of the bandwidth, which ranges
from 1 to 100 percent. This mode is invalid if PPS is enabled.
pps: Specify the upper rate limit in packets per second, which ranges from 1 to
1488000 packets per second. This mode is invalid if PPS is disabled.
To disable the broadcast rate control, select Disable in the Broadcast field.
Multicast Rate
Mode / Multicast
To enable the multicast rate control, select a multicast rate mode and specify the
upper rate limit for receiving broadcast packets in the Multicast field. The packet
traffic exceeding the rate will be discarded.
The switch supports the following three rate modes:
kbps: Specify the upper rate limit in kilo-bits per second, which ranges from 1 to
1000000 kbps. This mode is invalid if PPS is enabled.
ratio: Specify the upper rate limit as a percentage of the bandwidth, which ranges
from 1 to 100 percent. This mode is invalid if PPS is enabled.
pps: Specify the upper rate limit in packets per second, which ranges from 1 to
1488000 packets per second. This mode is invalid if PPS is disabled.
To disable the multicast rate control, select Disable in the Multicast field.
UL-Frame Rate
Mode / UL-
Frame
To enable the UL-Frame (Unknown unicast frame) rate control, select a UL-Frame
rate mode and specify the upper rate limit for receiving UL-Frames in the UL-
Frame field. The packet traffic exceeding the rate will be discarded. The switch
supports the following three rate modes:
kbps: Specify the upper rate limit in kilo-bits per second, which ranges from 1 to
1000000 kbps. This mode is invalid if PPS is enabled.
ratio: Specify the upper rate limit as a percentage of the bandwidth, which ranges
from 1 to 100 percent. This mode is invalid if PPS is enabled.
pps: Specify the upper rate limit in packets per second, which ranges from 1 to
1488000 packets per second. This mode is invalid if PPS is disabled.
To disable the UL-Frame rate control, select Disable in the UL-Frame field.
LAG Displays the aggregation group which the port is in.
2) Click Apply.

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English