TP-Link T1600G-52PS - Page 477

Configuration Guide 454
Configuring QoS Bandwidth Control Configuration
Note:
T1600G-18TS does not support the PPS related features.
The following example shows how to configure the upper rate limit of broadcast packets as
148800 pps on port 1/0/5:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/5
Switch(config-if)#storm-control pps
Switch(config-if)#storm-control broadcast pps 148800
Switch(config-if)#show storm-control interface gigabitEthernet 1/0/5
Port BcRate Mcate UlRate LAG
--------- ---------------- -------------- -------------- -------------
Gi1/0/5 pps 148800 pps 0 pps 0 N/A
Switch(config-if)#end
Switch#copy running-config startup-config
The following example shows how to configure the upper rate limit of broadcast packets as
10240 kbps on port 1/0/5:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/5
Switch(config-if)#no storm-control pps
Switch(config-if)#storm-control broadcast kbps 10240
Switch(config-if)#show storm-control interface gigabitEthernet 1/0/5
Port BcRate Mcate UlRate LAG
--------- ---------------- -------------- -------------- -------------
Gi1/0/5 kbps 10240 kbps 0 kbps 0 N/A
Switch(config-if)#end
Switch#copy running-config startup-config