TP-Link T1600G-52PS - Page 504

Configuring Voice VLAN Configuration Example
Configuration Guide
481
Switch_A(config-if)#switchport voice vlan mode auto
Switch_A(config-if)#switchport voice vlan security
Switch_A(config-if)#exit
4) Configure port 1/0/2 to manual voice VLAN mode, and add it to the voice VLAN as a
tagged port.
Switch_A(config)#interface gigabitEthernet 1/0/2
Switch_A(config-if)#switchport voice vlan mode manual
Switch_A(config-if)#switchport general allowed vlan 10 tagged
Switch_A(config-if)#exit
5) Enable LLDP globally and set the fast start count of LLDP-MED frame as 4.
Switch_A(config)#lldp
Switch_A(config)# lldp med-fast-count 4
6) Enable the LLDP-MED feature on port 1/0/1.
Switch_A(config)#interface gigabitEthernet 1/0/1
Switch_A(config-if)#lldp med-status
7) Select all MED TLVs to be carried in LLDP frames and sent out by port 1/0/1.
Switch_A(config-if)#lldp med-tlv-select all
8) Configure the location identification parameters for the IP phone on port 1/0/1. For
details about LLDP-MED, please refer to
Configuring LLDP
.
Switch(config-if)#lldp med-location civic-address language English city Vancouver
street X east hastings street postal-zipcode V6A 1P9
Switch_A(config-if)#end
Switch_A#copy running-config startup-config

Configurations for Switch B
1) Create VLAN 10.
Switch_B#configure
Switch_B(config)#vlan 10
Switch_B(config-vlan)#name VoiceVLAN
Switch_B(config-vlan)#exit
2) Set the 802.1p priority of voice packets as 6 and VLAN 10 as the voice VLAN.
Switch_B(config)#voice vlan priority 6
Switch_B(config)#voice vlan 10