Configuration Guide 587
Configuring Network Security AAA Configuration
Follow these steps to add a RADIUS server:
1) In the Server Config section, configure the following parameters.
Server IP Enter the IP address of the server running the RADIUS secure protocol.
Shared Key Enter the shared key between the RADIUS server and the switch. The RADIUS
server and the switch use the key string to encrypt passwords and exchange
responses.
Auth Port Specify the UDP destination port on the RADIUS server for authentication
requests. The default setting is 1812.
Acct Port Specify the UDP destination port on the RADIUS server for accounting requests.
The default setting is 1813. Usually, it is used in the 802.1X feature.
Retransmit Specify the number of times a request is resent to the server if the server does
not respond. The default setting is 2.
Timeout Specify the time interval that the switch waits for the server to reply before
resending. The default setting is 5 seconds.
2) Click Add to add the RADIUS server on the switch.

Adding TACACS+ Server
Choose the menu Network Security > AAA > TACACS+ Conifg to load the following page.
Figure 7-3 TACACS+ Server Configuration
Follow these steps to add a TACACS+ server:
1) In the Server Config section, configure the following parameters.
Server IP Enter the IP address of the server running the TACACS+ secure protocol.
Timeout Specify the time interval that the switch waits for the server to reply before
resending. The default setting is 5 seconds.
To Next Page
Loading...
Need help?
General