Configuring Maintenance System Log Configurations
Configuration Guide
683
The following example shows how to set the remote log on the switch. Enable log host 2,
set its IP address as 192.168.0.148, and allow logs of levels 0 to 5 to be sent to the host:
Switch#configure
Switch(config)# logging host index 2 192.168.0.148 5
Switch(config)# show logging loghost
Index Host-IP Severity Status
----- ------- -------- ------
1 0.0.0.0 6 disable
2 192.168.0.148 5 enable
3 0.0.0.0 6 disable
4 0.0.0.0 6 disable
Switch(config)#end
Switch#copy running-config startup-config
To Next Page
Loading...
Need help?
General