Configuration Guide 738
Configuring SNMP & RMON Configuration Example
Switch(config)#rmon history 2 interface gigabitEthernet 1/0/2 interval 100 owner
monitor buckets 50
3) Create two event entries named admin, which is the SNMP user name. Set entry 1 as
the Notify type and its description as “rising notify”. Set entry 2 as the Log type and its
description as “falling log”. Set the owner of them as monitor.
Switch(config)#rmon event 1 user admin description rising-notify type notify owner
monitor
Switch(config)#rmon event 2 user admin description falling-log type log owner monitor
4) Create two alarm entries. For entry 1, set the alarm variable as BPackets, associated
statistics entry ID as 1 (bound to port 1/0/1), the sample type as Absolute, the rising
threshold as 3000, the associated rising event entry ID as 1 (Notify type), the falling
threshold as 2000, the associated falling event entry ID as 2 (the log type), the alarm
type as all, the interval as 10 seconds, and the owner name as monitor. For entry
2, set the associated statistics entry ID as 2 (bound to port 1/0/2), while all other
configurations are the same as those of entry 1.
Switch(config)#rmon alarm 1 stats-index 1 alarm-variable bpkt s-type absolute rising-
threshold 3000 rising-event-index 1 falling-threshold 2000 falling-event-index 2 a-type
all interval 10 owner monitor
Switch(config)#rmon alarm 2 stats-index 2 alarm-variable bpkt s-type absolute rising-
threshold 3000 rising-event-index 1 falling-threshold 2000 falling-event-index 2 a-type
all interval 10 owner monitor
Verify the Configurations
Verify global SNMP configurations:
Switch(config)#show snmp-server
SNMP agent is enabled.
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
To Next Page
Loading...
