C
HAPTER
45
| IP Routing Commands
Routing Information Protocol (RIP)
– 1028 –
COMMAND MODE
Router Configuration
COMMAND USAGE
â—† Administrative distance is used by the routers to select the preferred
path when there are two or more different routes to the same
destination from two different routing protocols. A smaller
administrative distance indicates a more reliable protocol.
â—† An access list can be used to filter networks according to the IP address
of the router supplying the routing information. For example, to filter
out unreliable routing information from routers not under your
administrative control.
â—† The administrative distance is applied to all routes learned for the
specified network.
EXAMPLE
Console(config-router)#distance 2 192.168.3.0 255.255.255.0
Console(config-router)#
maximum-prefix This command sets the maximum number of RIP routes allowed by the
system. Use the no form to restore the default setting.
SYNTAX
maximum-prefix maximum-routes
no maximum-prefix
maximum-routes - The maximum number of RIP routes which can
be installed in the routing table. (Range: 1-7168)
DEFAULT SETTING
1024
COMMAND MODE
Router Configuration
COMMAND USAGE
All the learned RIP routes may not be copied to the hardware tables in
ASIC for fast data forwarding because of hardware resource limitations.
EXAMPLE
Console(config-router)#maximum-prefix 1024
Console(config-router)#
To Next Page
Loading...
Need help?
General
