C
HAPTER
13
| Security Measures
Access Control Lists
– 292 –
CONFIGURING A
STANDARD IPV6 ACL
Use the Security > ACL (Configure ACL - Add Rule - IPv6 Standard) page to
configure a Standard IPv6ACL.
CLI REFERENCES
◆ "permit, deny (Standard IPv6 ACL)" on page 755
◆ "show ipv6 access-list" on page 758
◆ "Time Range" on page 625
PARAMETERS
These parameters are displayed in the web interface:
◆ Type – Selects the type of ACLs to show in the Name list.
◆ Name – Shows the names of ACLs matching the selected type.
◆ Action – An ACL can contain any combination of permit or deny rules.
◆ Source Address Type – Specifies the source IP address. Use “Any” to
include all possible addresses, “Host” to specify a specific host address
in the Address field, or “IPv6-prefix” to specify a range of addresses.
(Options: Any, Host, IPv6-prefix; Default: Any)
◆ Source IPv6 Address – An IPv6 source address or network class. The
address must be formatted according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields.
◆ Source Prefix-Length – A decimal value indicating how many
contiguous bits (from the left) of the address comprise the prefix (i.e.,
the network portion of the address).
◆ Time Range – Name of a time range.
WEB INTERFACE
To add rules to a Standard IPv6 ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select IPv6 Standard from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the source address type (Any, Host, or IPv6-prefix).
To Next Page
Loading...
Need help?
General
