C
HAPTER
24
| System Management Commands
Time Range
– 626 –
absolute This command sets the time range for the execution of a command. Use
the no form to remove a previously specified time.
SYNTAX
absolute start hour minute day month year
[end hour minutes day month year]
absolute end hour minutes day month year
no absolute
hour - Hour in 24-hour format. (Range: 0-23)
minute - Minute. (Range: 0-59)
day - Day of month. (Range: 1-31)
month - january | february | march | april | may | june | july |
august | september | october | november | december
year - Year (4-digit). (Range: 2009-2109)
DEFAULT SETTING
None
COMMAND MODE
Time Range Configuration
COMMAND USAGE
If a time range is already configured, you must use the no form of this
command to remove the current entry prior to configuring a new time
range.
EXAMPLE
This example configures the time for the single occurrence of an event.
Console(config)#time-range r&d
Console(config-time-range)#absolute start 1 1 1 april 2009 end 2 1 1 april
2009
Console(config-time-range)#
periodic This command sets the time range for the periodic execution of a
command. Use the no form to remove a previously specified time range.
SYNTAX
[no] periodic {daily | friday | monday | saturday | sunday |
thursday | tuesday | wednesday | weekdays | weekend}
hour minute to {daily | friday | monday | saturday | sunday |
thursday | tuesday | wednesday | weekdays | weekend |
hour minute}
daily - Daily
friday - Friday
To Next Page
Loading...
Need help?
General
