C
HAPTER
24
| System Management Commands
File Management
– 594 –
“Factory_Default_Config.cfg” can be copied to the FTP/TFTP server, but
cannot be used as the destination on the switch.
boot system This command specifies the file or image used to start up the system.
SYNTAX
boot system {boot-rom | config | opcode}: filename
boot-rom* - Boot ROM.
config* - Configuration file.
opcode* - Run-time operation code.
filename - Name of configuration file or code image.
* The colon (:) is required.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ A colon (:) is required after the specified file type.
◆ If the file contains an error, it cannot be set as the default file.
EXAMPLE
Console(config)#boot system config: startup
Console(config)#
RELATED COMMANDS
dir (598)
whichboot (599)
Table 36: Flash/File Commands
Command Function Mode
boot system Specifies the file or image used to start up the
system
GC
copy Copies a code image or a switch configuration to or
from flash memory or an FTP/TFTP server
PE
delete Deletes a file or code image PE
dir Displays a list of files in flash memory PE
whichboot Displays the files booted PE
To Next Page
Loading...
Need help?
General
