EasyManuals Logo

Edge-Core ECS4610-24F User Manual

Edge-Core ECS4610-24F
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1005 background imageLoading...
Page #1005 background image
– 1005 –
44 IP INTERFACE COMMANDS
An IP address may be used for management access to the switch over the
network. You can manually configure a specific address or direct the switch
to obtain an address from a BOOTP or DHCP server when it is powered on.
An address for this switch is obtained via DHCP by default for VLAN 1. You
may also need to a establish a default gateway between this device and
management stations that exist on another network segment.
IP INTERFACE
There are no IP addresses assigned to this switch by default. You must
manually configure a new address to manage the switch over your network
or to connect the switch to existing IP subnets. You may also need to a
establish a default gateway between this device and management stations
or other devices that exist on another network segment (if routing is not
enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP.
Table 135: IP Interface Commands
Command Group Function
Basic IP Configuration Configures the IP address for interfaces and the gateway router
ARP Configuration Configures static, dynamic and proxy ARP service
UDP Helper Configuration Forwards UDP broadcast packets to a specified server

Table of Contents

Other manuals for Edge-Core ECS4610-24F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS4610-24F and is the answer not in the manual?

Edge-Core ECS4610-24F Specifications

General IconGeneral
BrandEdge-Core
ModelECS4610-24F
CategoryNetwork Router
LanguageEnglish

Related product manuals