Edge-Core ECS4610-24F

C HAPTER 27 | Authentication Commands
AAA
– 672 –
aaa accounting exec This command enables the accounting of requested Exec services for
network access. Use the no form to disable the accounting service.
SYNTAX
aaa accounting exec {default | method-name}
start-stop group {radius | tacacs+ |server-group}
no aaa accounting exec {default | method-name}
default - Specifies the default accounting method for service
requests.
method-name - Specifies an accounting method for service
requests. (Range: 1-255 characters)
start-stop - Records accounting from starting point and stopping
point.
group - Specifies the server group to use.
radius - Specifies all RADIUS hosts configure with the radius-
server host command.
tacacs+ - Specifies all TACACS+ hosts configure with the
tacacs-server host command.
server-group - Specifies the name of a server group configured
with the aaa group server command. (Range: 1-255 characters)
DEFAULT SETTING
Accounting is not enabled
No servers are specified
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ This command runs accounting for Exec service requests for the local
console and Telnet connections.
◆ Note that the default and method-name fields are only used to
describe the accounting method(s) configured on the specified RADIUS
or TACACS+ servers, and do not actually send any information to the
servers about the methods to use.
EXAMPLE
Console(config)#aaa accounting exec default start-stop group tacacs+
Console(config)#