C
HAPTER
27
| Authentication Commands
AAA
– 674 –
DEFAULT SETTING
Authorization is not enabled
No servers are specified
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† This command performs authorization to determine if a user is allowed
to run an Exec shell.
â—† AAA authentication must be enabled before authorization is enabled.
â—† If this command is issued without a specified named method, the
default method list is applied to all interfaces or lines (where this
authorization type applies), except those that have a named method
explicitly defined.
EXAMPLE
Console(config)#aaa authorization exec default group tacacs+
Console(config)#
aaa group server Use this command to name a group of security server hosts. To remove a
server group from the configuration list, enter the no form of this
command.
SYNTAX
[no] aaa group server {radius | tacacs+} group-name
radius - Defines a RADIUS server group.
tacacs+ - Defines a TACACS+ server group.
group-name - A text string that names a security server group.
(Range: 1-7 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#aaa group server radius tps
Console(config-sg-radius)#