C
HAPTER
40
| LLDP Commands
– 957 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv management-ip-address
Console(config-if)#
lldp basic-tlv port-
description
This command configures an LLDP-enabled port to advertise its port
description. Use the no form to disable this feature.
SYNTAX
[no] lldp basic-tlv port-description
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
The port description is taken from the ifDescr object in RFC 2863, which
includes information about the manufacturer, the product name, and the
version of the interface hardware/software.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv port-description
Console(config-if)#
lldp basic-tlv
system-capabilities
This command configures an LLDP-enabled port to advertise its system
capabilities. Use the no form to disable this feature.
SYNTAX
[no] lldp basic-tlv system-capabilities
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
The system capabilities identifies the primary function(s) of the system and
whether or not these primary functions are enabled. The information
advertised by this TLV is described in IEEE 802.1AB.
To Next Page
Loading...
Need help?
General
