C
HAPTER
13
| Security Measures
Access Control Lists
– 300 –
BINDING A PORT TO AN
ACCESS CONTROL
LIST
After configuring ACLs, use the Security > ACL (Configure Interface) page
to bind the ports that need to filter traffic to the appropriate ACLs. You can
assign one IP access list and one MAC access list to any port.
CLI REFERENCES
◆ "ip access-group" on page 752
◆ "ipv6 access-group" on page 759
◆ "show ip access-group" on page 753
◆ "show ipv6 access-group" on page 759
◆ "mac access-group" on page 763
◆ "show mac access-group" on page 764
◆ "Time Range" on page 625
COMMAND USAGE
◆ This switch supports ACLs for ingress filtering only.
◆ You only bind one ACL to any port for ingress filtering.
PARAMETERS
These parameters are displayed in the web interface:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Port identifier
◆ ACL – ACL used for ingress packets.
◆ Time Range – Name of a time range.
WEB INTERFACE
To bind an ACL to a port:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select IP or MAC from the Type list.
4. Select the name of an ACL from the ACL list.
5. Click Apply.
To Next Page
Loading...
