C
HAPTER
24
| System Management Commands
System Status
– 590 –
RELATED COMMANDS
show startup-config (590)
show startup-config This command displays the configuration file stored in non-volatile memory
that is used to start up the system.
COMMAND MODE
Privileged Exec
COMMAND USAGE
◆ Use this command in conjunction with the show running-config
command to compare the information in running memory to the
information stored in non-volatile memory.
◆ This command displays settings for key command modes. Each mode
group is separated by “!” symbols, and includes the configuration mode
command, and corresponding commands. This command displays the
following information:
■
MAC address for the switch
■
SNMP community strings
■
Users (names, access levels, and encrypted passwords)
■
VLAN database (VLAN ID, name and state)
■
VLAN configuration settings for each interface
■
Multiple spanning tree instances (name and interfaces)
■
IP address configured for VLANs
■
Layer 4 precedence settings
■
Routing protocol configuration settings
■
Spanning tree settings
■
Interface settings
■
Any configured settings for the console port and Telnet
EXAMPLE
Refer to the example for the running configuration file.
RELATED COMMANDS
show running-config (588)
show system This command displays system information.
DEFAULT SETTING
None
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
◆ For a description of the items shown by this command, refer to
"Displaying System Information" on page 101.
To Next Page
Loading...
Need help?
General
