C
HAPTER
27
| Authentication Commands
Telnet Server
– 681 –
ip http secure-port This command specifies the UDP port number used for HTTPS connection to
the switch’s web interface. Use the no form to restore the default port.
SYNTAX
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS. (Range: 1-65535)
DEFAULT SETTING
443
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† You cannot configure the HTTP and HTTPS servers to use the same
port.
â—† If you change the HTTPS port number, clients attempting to connect to
the HTTPS server must specify the port number in the URL, in this
format: https://device:port_number
EXAMPLE
Console(config)#ip http secure-port 1000
Console(config)#
RELATED COMMANDS
ip http secure-server (679)
show system (590)
TELNET SERVER
This section describes commands used to configure Telnet management
access to the switch.
Table 61: Telnet Server Commands
Command Function Mode
ip telnet max-sessions Specifies the maximum number of Telnet sessions
that can simultaneously connect to this system
GC
ip telnet port Specifies the port to be used by the Telnet interface GC
ip telnet server Allows the switch to be monitored or configured from
Tel ne t
GC
show ip telnet Displays configuration settings for the Telnet server PE
To Next Page
Loading...
Need help?
General
