C
HAPTER
24
| System Management Commands
Time Range
– 625 –
TIME RANGE
This section describes the commands used to sets a time range for use by
other functions, such as Access Control Lists.
time-range This command specifies the name of a time range, and enters time range
configuration mode. Use the no form to remove a previously specified time
range.
SYNTAX
[no] time-range name
name - Name of the time range. (Range: 1-30 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets a time range for use by other functions, such as Access
Control Lists.
EXAMPLE
Console(config)#time-range r&d
Console(config-time-range)#
RELATED COMMANDS
Access Control Lists (747)
Table 45: Time Range Commands
Command Function Mode
time-range Specifies the name of a time range, and enters time
range configuration mode
GC
absolute Sets the time range for the execution of a command TR
periodic Sets the time range for the periodic execution of a
command
TR
To Next Page
Loading...
Need help?
General
