C
HAPTER
6
| VLAN Configuration
Protocol VLANs
– 180 –
MAPPING PROTOCOL
GROUPS TO
INTERFACES
Use the VLAN > Protocol (Configure Interface - Add) page to map a
protocol group to a VLAN for each interface that will participate in the
group.
CLI REFERENCES
â—† "protocol-vlan protocol-group (Configuring Interfaces)" on page 858
COMMAND USAGE
â—† When creating a protocol-based VLAN, only assign interfaces using this
configuration screen. If you assign interfaces using any of the other
VLAN menus such as the VLAN Static table (page 158), these interfaces
will admit traffic of any protocol type into the associated VLAN.
â—† When a frame enters a port that has been assigned to a protocol VLAN,
it is processed in the following manner:
â–
If the frame is tagged, it will be processed according to the standard
rules applied to tagged frames.
â–
If the frame is untagged and the protocol type matches, the frame
is forwarded to the appropriate VLAN.
â–
If the frame is untagged but the protocol type does not match, the
frame is forwarded to the default VLAN for this interface.
PARAMETERS
These parameters are displayed in the web interface:
◆ Interface – Displays a list of ports or trunks.
◆ Port – Port Identifier. (Range: 1-24)
◆ Trunk – Trunk Identifier. (Range: 1-32)
◆ Protocol Group ID – Protocol Group ID assigned to the Protocol VLAN
Group. (Range: 1-2147483647)
◆ VLAN ID – VLAN to which matching protocol traffic is forwarded.
(Range: 1-4093)
WEB INTERFACE
To map a protocol group to a VLAN for a port or trunk:
1. Click VLAN, Protocol.
2. Select Configure Interface from the Step list.
3. Select Add from the Action list.
4. Select a port or trunk.
5. Enter the identifier for a protocol group.
To Next Page
Loading...
Need help?
General
