C
HAPTER
45
| IP Routing Commands
Routing Information Protocol (RIP)
– 1025 –
router rip This command enables Routing Information Protocol (RIP) routing for all IP
interfaces on the router. Use the no form to disable it.
SYNTAX
[no] router rip
COMMAND MODE
Global Configuration
DEFAULT SETTING
Disabled
COMMAND USAGE
â—† RIP is used to specify how routers exchange routing table information.
â—† This command is also used to enter router configuration mode.
EXAMPLE
Console(config)#router rip
Console(config-router)#
RELATED COMMANDS
network (1029)
ip rip receive version Sets the RIP receive version to use on a network
interface
IC
ip rip receive-packet Configures the interface to receive of RIP packets IC
ip rip send version Sets the RIP send version to use on a network
interface
IC
ip rip send-packet Configures the interface to send RIP packets IC
ip rip split-horizon Enables split-horizon or poison-reverse loop
prevention
IC
clear ip rip route Clears specified data from the RIP routing table PE
show ip protocols rip Displays RIP process parameters PE
show ip rip Displays information about RIP routes and
configuration settings
PE
Table 141: Routing Information Protocol Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General
