Edge-Core ECS4610-24F User Manual

C HAPTER 28 | General Security Measures
Network Access (MAC Address Authentication)
– 716 –
COMMAND MODE
Interface Configuration
COMMAND USAGE
◆ The VLAN to be used as the guest VLAN must be defined and set as
active (See the vlan database command).
◆ When used with 802.1X authentication, the intrusion-action must be
set for “guest-vlan” to be effective (see the dot1x intrusion-action
command).
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access guest-vlan 25
Console(config-if)#
network-access
link-detection
Use this command to enable link detection for the selected port. Use the
no form of this command to restore the default.
SYNTAX
[no] network-access link-detection
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#

Edge-Core ECS4610-24F Specifications

General

Model	ECS4610-24F
Switching Capacity	128 Gbps
MAC Address Table Size	16K
Jumbo Frames	9K Bytes
Operating Humidity	10% to 90% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)
Layer	L2/L3
Forwarding Rate	95.2 Mpps
VLANs	4K
Management	Web, CLI, SNMP
Power Supply	Internal
Dimensions (W x D x H)	440 x 44 x mm
Operating Temperature	0°C
Storage Temperature	-40°C to 70°C
Ports	24 x 1G SFP ports, 4 x 10G SFP+ ports