C
HAPTER
46
| Multicast Routing Commands
Static Multicast Routing
– 1088 –
This example lists all entries in the multicast table in summary form:
Console#show ip mroute summary
IP Multicast Forwarding is enabled
IP Multicast Routing Table (Summary)
Flags: F – Forwarding, P - Pruned
Group Source Source Mask Interface Owner Flags
--------------- --------------- --------------- ---------- ------- ------
224.0.17.17 192.168.2.1 255.255.255.255 VLAN2 PIM-DM F
Total Entry is 1
Console#
STATIC MULTICAST ROUTING
This section describes commands used to configure static multicast routes
on the switch.
ip igmp snooping
vlan mrouter
This command statically configures a multicast router port. Use the no
form to remove the configuration.
SYNTAX
ip igmp snooping vlan vlan-id mrouter interface
no ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4093)
interface
ethernet unit/port
unit - This is device 1.
port - Port number.
port-channel channel-id (Range: 1-32)
DEFAULT SETTING
No static multicast router ports are configured.
COMMAND MODE
Global Configuration
Table 157: Static Multicast Routing Commands
Command Function Mode
ip igmp snooping vlan
mrouter
Adds a multicast router port GC
show ip igmp snooping
mrouter
Shows multicast router ports PE
To Next Page
Loading...
Need help?
General
