C
HAPTER
35
| Spanning Tree Commands
– 817 –
COMMAND MODE
MST Configuration
COMMAND USAGE
The MST region name and revision number (page 817) are used to
designate a unique MST region. A bridge (i.e., spanning-tree compliant
device such as this switch) can only belong to one MST region. And all
bridges in the same region must be configured with the same MST
instances.
EXAMPLE
Console(config-mstp)#name R&D
Console(config-mstp)#
RELATED COMMANDS
revision (817)
revision This command configures the revision number for this multiple spanning
tree configuration of this switch. Use the no form to restore the default.
SYNTAX
revision number
number - Revision number of the spanning tree. (Range: 0-65535)
DEFAULT SETTING
0
COMMAND MODE
MST Configuration
COMMAND USAGE
The MST region name (page 816) and revision number are used to
designate a unique MST region. A bridge (i.e., spanning-tree compliant
device such as this switch) can only belong to one MST region. And all
bridges in the same region must be configured with the same MST
instances.
EXAMPLE
Console(config-mstp)#revision 1
Console(config-mstp)#
RELATED COMMANDS
name (816)
To Next Page
Loading...
Need help?
General
