C
HAPTER
42
| DHCP Commands
DHCP Server
– 982 –
Split horizon is enabled
Console#
RELATED COMMANDS
ip dhcp relay server (980)
DHCP SERVER
This section describes commands used to configure client address pools for
the DHCP service.
Table 131: DHCP Server Commands
Command Function Mode
ip dhcp excluded-address Specifies IP addresses that a DHCP server should not
assign to DHCP clients
GC
ip dhcp pool Configures a DHCP address pool on a DHCP Server GC
service dhcp Enables the DHCP server feature on this switch GC
bootfile Specifies a default boot image for a DHCP client DC
client-identifier
*
Specifies a client identifier for a DHCP client DC
default-router Specifies the default router list for a DHCP client DC
dns-server Specifies the Domain Name Server (DNS) servers
available to a DHCP client
DC
domain-name Specifies the domain name for a DHCP client DC
hardware-address
*
Specifies the hardware address of a DHCP client DC
host
*
* These commands are used for manually binding an address to a client.
Specifies the IP address and network mask to
manually bind to a DHCP client
DC
lease Sets the duration an IP address is assigned to a DHCP
client
DC
netbios-name-server Configures NetBIOS Windows Internet Naming Service
(WINS) name servers available to Microsoft DHCP
clients
DC
netbios-node-type Configures NetBIOS node type for Microsoft DHCP
clients
DC
network Configures the subnet number and mask for a DHCP
address pool
DC
next-server Configures the next server in the boot process of a
DHCP client
DC
clear ip dhcp binding Deletes an automatic address binding from the DHCP
server database
PE
show ip dhcp binding Displays address bindings on the DHCP server PE, NE
show ip dhcp Dsplays DHCP address pools PE
To Next Page
Loading...
Need help?
General
