C
HAPTER
30
| Interface Commands
– 781 –
MTU : 1518
Current Status:
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 100full
Flow Control Type : None
Console#
show interfaces
switchport
This command displays the administrative and operational status of the
specified interfaces.
SYNTAX
show interfaces switchport [interface]
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-24)
port-channel channel-id (Range: 1-32)
DEFAULT SETTING
Shows all interfaces.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
If no interface is specified, information on all interfaces is displayed.
EXAMPLE
This example shows the configuration setting for port 21.
Console#show interfaces switchport ethernet 1/21
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second
Egress Rate Limit : Disabled, 1000M bits per second
VLAN Membership Mode : Hybrid
Ingress Rule : Disabled
Acceptable Frame Type : All frames
Native VLAN : 1
Priority for Untagged Traffic : 0
GVRP Status : Disabled
Allowed VLAN : 1(u)
Forbidden VLAN :
Private-VLAN Mode : None
Private-VLAN host-association : None
Private-VLAN Mapping: None
802.1Q-tunnel Status: Disable
802.1Q-tunnel Mode: NORMAL
802.1Q-tunnel TPID: 8100(Hex)
To Next Page
Loading...
Need help?
General
