C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 366 –
To show SNMP groups:
1. Click Administration, SNMP.
2. Select Configure Group from the Step list.
3. Select Show from the Action list.
Figure 204: Showing SNMP Groups
SETTING COMMUNITY
ACCESS STRINGS
Use the Administration > SNMP (Configure User - Add Community) page to
configure up to five community strings authorized for management access
by clients using SNMP v1 and v2c. For security reasons, you should
consider removing the default strings.
CLI REFERENCES
◆ "snmp-server community" on page 630
PARAMETERS
These parameters are displayed in the web interface:
◆ Community String – A community string that acts like a password
and permits access to the SNMP protocol.
Range: 1-32 characters, case sensitive
Default strings: “public” (Read-Only), “private” (Read/Write)
◆ Access Mode – Specifies the access rights for the community string:
■
Read-Only – Authorized management stations are only able to
retrieve MIB objects.
■
Read/Write – Authorized management stations are able to both
retrieve and modify MIB objects.
To Next Page
Loading...
Need help?
General
