C
HAPTER
36
| VLAN Commands
Displaying VLAN Information
– 845 –
Console(config-if)#vlan-trunking
Console(config-if)#
DISPLAYING VLAN INFORMATION
This section describes commands used to display VLAN information.
show vlan This command shows VLAN information.
SYNTAX
show vlan [id vlan-id | name vlan-name]
id - Keyword to be followed by the VLAN ID.
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading
zeroes)
name - Keyword to be followed by the VLAN name.
vlan-name - ASCII string from 1 to 32 characters.
DEFAULT SETTING
Shows all VLANs.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
The following example shows how to display information for VLAN 1:
Console#show vlan id 1
VLAN ID : 1
Type : Static
Name : DefaultVlan
Status : Active
Ports/Port Channels : Eth1/ 1(S) Eth1/ 2(S) Eth1/ 3(S) Eth1/ 4(S) Eth1/ 5(S)
Eth1/ 6(S) Eth1/ 7(S) Eth1/ 8(S) Eth1/ 9(S) Eth1/10(S)
Eth1/11(S) Eth1/12(S) Eth1/13(S) Eth1/14(S) Eth1/15(S)
Eth1/16(S) Eth1/17(S) Eth1/18(S) Eth1/19(S) Eth1/20(S)
Eth1/21(S) Eth1/22(S) Eth1/23(S) Eth1/24(S) Eth1/25(S)
Eth1/26(S)
Console#
Table 97: Commands for Displaying VLAN Information
Command Function Mode
show interfaces status
vlan
Displays status for the specified VLAN interface NE, PE
show interfaces
switchport
Displays the administrative and operational status of
an interface
NE, PE
show vlan Shows VLAN information NE, PE
To Next Page
Loading...
Need help?
General
