C
HAPTER
24
| System Management Commands
Event Logging
– 612 –
logging host This command adds a syslog server host IP address that will receive
logging messages. Use the no form to remove a syslog server host.
SYNTAX
[no] logging host host-ip-address
host-ip-address - The IPv4 or IPv6 address of a syslog server.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† Use this command more than once to build up a list of host IP
addresses.
â—† The maximum number of host IP addresses allowed is five.
EXAMPLE
Console(config)#logging host 10.1.0.3
Console(config)#
logging on This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
SYNTAX
[no] logging on
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
The logging process controls error messages saved to switch memory or
sent to remote syslog servers. You can use the logging history command to
control the type of error messages that are stored in memory. You can use
the logging trap command to control the type of error messages that are
sent to specified syslog servers.
EXAMPLE
Console(config)#logging on
Console(config)#
To Next Page
Loading...
Need help?
General
