C
HAPTER
46
| Multicast Routing Commands
PIM Multicast Routing
– 1100 –
EXAMPLE
Console(config-if)#ip pim graft-retry-interval 9
Console(config-if)#
ip pim max-graft-
retries
This command configures the maximum number of times to resend a Graft
message if it has not been acknowledged. Use the no form to restore the
default value.
SYNTAX
ip pim max-graft-retries retries
no ip pim max-graft-retries
retries - The maximum number of times to resend a Graft.
(Range: 1-10)
DEFAULT SETTING
3
COMMAND MODE
Interface Configuration (VLAN)
EXAMPLE
Console(config-if)#ip pim max-graft-retries 5
Console(config-if)#
ip pim state-refresh
origination-interval
This command sets the interval between sending PIM-DM state refresh
control messages. Use the no form to restore the default value.
SYNTAX
ip pim state-refresh origination-interval seconds
no ip pim max-graft-retries
seconds - The interval between sending PIM-DM state refresh
control messages. (Range: 1-100 seconds)
DEFAULT SETTING
60 seconds
COMMAND MODE
Interface Configuration (VLAN)
COMMAND USAGE
â—† The pruned state times out approximately every three minutes and the
entire PIM-DM network is reflooded with multicast packets and prune
messages. The state refresh feature keeps the pruned state from
To Next Page
Loading...
Need help?
General
