C
HAPTER
27
| Authentication Commands
Web Server
– 679 –
RELATED COMMANDS
ip http server (679)
show system (590)
ip http server This command allows this device to be monitored or configured from a
browser. Use the no form to disable this function.
SYNTAX
[no] ip http server
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#ip http server
Console(config)#
RELATED COMMANDS
ip http port (678)
show system (590)
ip http secure-
server
This command enables the secure hypertext transfer protocol (HTTPS) over
the Secure Socket Layer (SSL), providing secure access (i.e., an encrypted
connection) to the switch’s web interface. Use the no form to disable this
function.
SYNTAX
[no] ip http secure-server
DEFAULT SETTING
Enabled
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† Both HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure the HTTP and HTTPS servers to
use the same UDP port.
â—† If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port_number]
To Next Page
Loading...
Need help?
General
