C
HAPTER
13
| Security Measures
Access Control Lists
– 293 –
8. If you select “Host,” enter a specific address. If you select “IPv6-prefix,”
enter a subnet address and the prefix length.
9. Click Apply.
Figure 158: Configuring a Standard IPv6 ACL
CONFIGURING AN
EXTENDED IPV6 ACL
Use the Security > ACL (Configure ACL - Add Rule - IPv6 Extended) page
to configure an Extended IPv6 ACL.
CLI REFERENCES
◆ "permit, deny (Extended IPv6 ACL)" on page 756
◆ "show ipv6 access-list" on page 758
◆ "Time Range" on page 625
PARAMETERS
These parameters are displayed in the web interface:
◆ Type – Selects the type of ACLs to show in the Name list.
◆ Name – Shows the names of ACLs matching the selected type.
◆ Action – An ACL can contain any combination of permit or deny rules.
◆ Destination Address Type – Specifies the destination IP address. Use
“Any” to include all possible addresses, or “IPv6-prefix” to specify a
range of addresses. (Options: Any, IPv6-prefix; Default: Any)
◆ Destination IPv6 Address – An IPv6 address or network class. The
address must be formatted according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (The switch only
checks the first 64 bits of the destination address.)
To Next Page
Loading...
Need help?
General
