C
HAPTER
4
| Basic Management Tasks
Managing System Files
– 110 –
SETTING THE START-
UP FILE
Use the System > File (Set Start-Up) page to specify the firmware or
configuration file to use for system initialization.
CLI REFERENCES
◆ "whichboot" on page 599
◆ "boot system" on page 594
WEB INTERFACE
To set a file to use for system initialization:
1. Click System, then File.
2. Select Set Start-Up from the Action list.
3. Mark the operation code or configuration file to be used at startup
4. Then click Apply.
Figure 9: Setting Start-Up Files
To start using the new firmware or configuration settings, reboot the
system via the System > Reset menu.
SHOWING SYSTEM
FILES
Use the System > File (Show) page to show the files in the system
directory, or to delete a file.
N
OTE
:
Files designated for start-up, and the Factory_Default_Config.cfg
file, cannot be deleted.
CLI REFERENCES
◆ "dir" on page 598
◆ "delete" on page 598
WEB INTERFACE
To show the system files:
1. Click System, then File.
To Next Page
Loading...
