C
HAPTER
45
| IP Routing Commands
Routing Information Protocol (RIP)
– 1024 –
destination unreachable messages
time exceeded messages
parameter problem message
echo request messages
echo reply messages
redirect messages
timestamp request messages
timestamp reply messages
source quench messages
address mask request messages
address mask reply messages
UDP Statistics:
2 input
no port errors
other errors
output
TCP Statistics:
4698 input
input errors
5867 output
Console#
ROUTING INFORMATION PROTOCOL (RIP)
.
Table 141: Routing Information Protocol Commands
Command Function Mode
router rip Enables the RIP routing protocol GC
default-information
originate
Generates a default external route into an autonomous
system
RC
default-metric Sets the default metric assigned to external routes
imported from other protocols
RC
distance Defines an administrative distance for external routes
learned from other routing protocols
RC
maximum-prefix Sets the maximum number of RIP routes allowed RC
neighbor Defines a neighboring router with which to exchange
information
RC
network Specifies the network interfaces that are to use RIP
routing
RC
passive-interface Stops RIP from sending routing updates on the
specified interface
RC
redistribute Redistribute routes from one routing domain to
another
RC
timers basic Sets basic timers, including update, timeout, garbage
collection
RC
version Specifies the RIP version to use on all network
interfaces (if not already specified with a receive
version or send version command)
RC
ip rip authentication
mode
Specifies the type of authentication used for RIP2
packets
IC
ip rip authentication
string
Enables authentication for RIP2 packets and specifies
keys
IC
To Next Page
Loading...
Need help?
General
