C
HAPTER
24
| System Management Commands
Time
– 622 –
RELATED COMMANDS
sntp client (620)
sntp server This command sets the IP address of the servers to which SNTP time
requests are issued. Use the this command with no arguments to clear all
time servers from the current list. Use the no form to clear all time servers
from the current list, or to clear a specific server.
SYNTAX
sntp server [ip1 [ip2 [ip3]]]
no sntp server [ip1 [ip2 [ip3]]]
ip - IPv4 or IPv6 address of an time server (NTP or SNTP).
(Range: 1 - 3 addresses)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
This command specifies time servers from which the switch will poll for
time updates when set to SNTP client mode. The client will poll the time
servers in the order specified until a response is received. It issues time
synchronization requests based on the interval set via the sntp poll
command.
EXAMPLE
Console(config)#sntp server 10.1.0.19
Console#
RELATED COMMANDS
sntp client (620)
sntp poll (621)
show sntp (622)
show sntp This command displays the current time and configuration settings for the
SNTP client, and indicates whether or not the local time has been properly
updated.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
This command displays the current time, the poll interval used for sending
time synchronization requests, and the current SNTP mode (i.e., unicast).
To Next Page
Loading...
Need help?
General
