C
HAPTER
27
| Authentication Commands
Management IP Filter
– 706 –
show management This command displays the client IP addresses that are allowed
management access to the switch through various protocols.
SYNTAX
show management {all-client | http-client | snmp-client |
telnet-client}
all-client - Displays IP addresses for all groups.
http-client - Displays IP addresses for the web group.
snmp-client - Displays IP addresses for the SNMP group.
telnet-client - Displays IP addresses for the Telnet group.
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show management all-client
Management IP Filter
HTTP Client:
Start IP Address End IP Address
--------------------------------------- ----------------------------------
192.168.1.19 192.168.1.19
SNMP Client:
Start IP Address End IP Address
--------------------------------------- -------------------------------------
192.168.1.19 192.168.1.19
Telnet Client:
Start IP Address End IP Address
--------------------------------------- -------------------------------------
192.168.1.19 192.168.1.19
Console#
To Next Page
Loading...
Need help?
General
