EasyManuals Logo

Edge-Core ECS4610-24F User Manual

Edge-Core ECS4610-24F
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #634 background imageLoading...
Page #634 background image
C
HAPTER
25
| SNMP Commands
– 634 –
RELATED COMMANDS
snmp-server host (634)
snmp-server host This command specifies the recipient of a Simple Network Management
Protocol notification operation. Use the no form to remove the specified
host.
SYNTAX
snmp-server host host-addr [inform [retry retries |
timeout seconds]] community-string
[version {1 | 2c | 3 {auth | noauth | priv} [udp-port port]}
no snmp-server host host-addr
host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
inform - Notifications are sent as inform messages. Note that this
option is only available for version 2c and 3 hosts. (Default: traps
are used)
retries - The maximum number of times to resend an inform
message if the recipient does not acknowledge receipt. (Range:
0-255; Default: 3)
seconds - The number of seconds to wait for an
acknowledgment before resending an inform message. (Range:
0-2147483647 centiseconds; Default: 1500 centiseconds)
community-string - Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you can
set this string using the snmp-server host command by itself, we
recommend defining it with the snmp-server community command
prior to using the snmp-server host command. (Maximum length:
32 characters)
version - Specifies whether to send notifications as SNMP Version
1, 2c or 3 traps. (Range: 1, 2c, 3; Default: 1)
auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy. See "Simple Network Management Protocol" on
page 354 for further information about these authentication and
encryption options.
port - Host UDP port to use. (Range: 1-65535; Default: 162)
DEFAULT SETTING
Host Address: None
Noti f ication Type: Traps
SNMP Version: 1
UDP Port: 162
COMMAND MODE
Global Configuration

Table of Contents

Other manuals for Edge-Core ECS4610-24F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS4610-24F and is the answer not in the manual?

Edge-Core ECS4610-24F Specifications

General IconGeneral
BrandEdge-Core
ModelECS4610-24F
CategoryNetwork Router
LanguageEnglish

Related product manuals