C
HAPTER
40
| LLDP Commands
– 960 –
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv proto-vid
Console(config-if)#
lldp dot1-tlv pvid This command configures an LLDP-enabled port to advertise its default
VLAN ID. Use the no form to disable this feature.
SYNTAX
[no] lldp dot1-tlv pvid
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
The port’s default VLAN identifier (PVID) indicates the VLAN with which
untagged or priority-tagged frames are associated (see the switchport
native vlan command).
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv pvid
Console(config-if)#
lldp dot1-tlv vlan-
name
This command configures an LLDP-enabled port to advertise its VLAN
name. Use the no form to disable this feature.
SYNTAX
[no] lldp dot1-tlv vlan-name
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
This option advertises the name of all VLANs to which this interface has
been assigned. See "switchport allowed vlan" on page 840 and "protocol-
vlan protocol-group (Configuring Interfaces)" on page 858.
To Next Page
Loading...
Need help?
General
