C
HAPTER
45
| IP Routing Commands
Routing Information Protocol (RIP)
– 1033 –
â—† These timers must be set to the same values for all routers in the
network.
EXAMPLE
This example sets the update timer to 40 seconds. The timeout timer is
subsequently set to 240 seconds, and the garbage-collection timer to 160
seconds.
Console(config-router)#timers basic 15
Console(config-router)#
version This command specifies a RIP version used globally by the router. Use the
no form to restore the default value.
SYNTAX
version {1 | 2}
no version
1 - RIP Version 1
2 - RIP Version 2
DEFAULT SETTING
Receive: Accepts RIPv1 or RIPv2 packets
Send: Route information is broadcast to other routers with RIPv2.
COMMAND MODE
Router Configuration
COMMAND USAGE
â—† When this command is used to specify a global RIP version, any VLAN
interface not previously set by the ip rip receive version or ip rip send
version command will use the global RIP version setting.
â—† When the no form of this command is used to restore the default value,
any VLAN interface not previously set by the ip rip receive version or ip
rip send version command will be set to the default send or receive
version.
â—† Any configured interface settings take precedence over the global
settings.
EXAMPLE
This example sets the global version for RIP to send and receive version 2
packets.
Console(config-router)#version 2
Console(config-router)#
To Next Page
Loading...
Need help?
General
