C
HAPTER
20
| Unicast Routing
Configuring the Routing Information Protocol
– 496 –
WEB INTERFACE
To define an administrative distance for external routes learned from other
routing protocols:
1. Click Routing Protocol, RIP, Distance.
2. Select Add from the Action list.
3. Enter the distance, the external route, and optionally enter the name of
an ACL to filter networks according to the IP address of the router
supplying the routing information.
4. Click Apply.
Figure 319: Setting the Distance Assigned to External Routes
To show the distance assigned to external routes learned from other
routing protocols:
1. Click Routing Protocol, RIP, Distance.
2. Select Show from the Action list.
Figure 320: Showing the Distance Assigned to External Routes
CONFIGURING
NETWORK INTERFACES
FOR RIP
Use the Routing Protocol > RIP > Distance (Add) page to configure the
send/recieve version, authentication settings, and the loopback prevention
method for each interface that participates in the RIP routing process.
CLI REFERENCES
â—† "ip rip receive version" on page 1035
â—† "ip rip send version" on page 1037
To Next Page
Loading...
Need help?
General
