Edge-Core ECS4610-24F User Manual

Name: Edge-Core ECS4610-24F
Brand: Edge-Core
Rating: 4 (1 reviews)

1154 pages

To Next Page

To Previous Page

HAPTER

| Authentication Commands

Secure Shell

– 688 –

EXAMPLE

Console#ip ssh crypto host-key generate dsa

Console#configure

Console(config)#ip ssh server

Console(config)#

RELATED COMMANDS

ip ssh crypto host-key generate (689)

show ssh (693)

ip ssh server-key

size

This command sets the SSH server key size. Use the no form to restore the

default setting.

SYNTAX

ip ssh server-key size key-size

no ip ssh server-key size

key-size – The size of server key. (Range: 512-896 bits)

DEFAULT SETTING

768 bits

COMMAND MODE

Global Configuration

COMMAND USAGE

The server key is a private key that is never shared outside the switch.

The host key is shared with the SSH client, and is fixed at 1024 bits.

EXAMPLE

Console(config)#ip ssh server-key size 512

Console(config)#

ip ssh timeout This command configures the timeout for the SSH server. Use the no form

to restore the default setting.

SYNTAX

ip ssh timeout seconds

no ip ssh timeout

seconds – The timeout for client response during SSH negotiation.

(Range: 1-120)

DEFAULT SETTING

10 seconds

Other manuals for Edge-Core ECS4610-24F

Installation Guide78 pages

Questions and Answers:

M
Mrs. Diane FischerAug 7, 2025
What to do if I cannot connect to Edge-Core Switch using Secure Shell?
- S
  Shelby BeckAug 8, 2025
  If you're having trouble connecting to the Edge-Core Switch using Secure Shell, it could be due to several reasons. You might have exceeded the maximum number of concurrent Telnet/SSH sessions, so try connecting again later. Ensure that the control parameters for the SSH server are properly configured on the switch and that the SSH client software is correctly configured on your management station. Verify that you've generated both an RSA and DSA public key on the switch, exported this key to the SSH client, and enabled the SSH service. Also, make sure you've set up an account on the switch for each SSH user, including the username, authentication level, and password. If using public key authentication, confirm that you've imported the client's public key to the switch.
D
Dustin MooreAug 14, 2025
What to do if the Link LED is off on my Edge-Core ECS4610-24F?
- V
  Vernon GreeneAug 14, 2025
  If the Link LED is off on your Edge-Core Network Router, there are several potential causes and solutions: * First, ensure that both the switch and the connected device are powered on. * Next, make sure the cable is securely plugged into both the switch and the corresponding device. * If the switch is in a rack, inspect the connections to the punch-down block and patch panel. * Verify you're using the correct cable type and that its length is within specified limits. * Inspect the adapter on the attached device and the cable connections for any defects, replacing them if needed. * Finally, if an SFP transceiver has failed, replace it.

Edge-Core ECS4610-24F Specifications

General

Model	ECS4610-24F
Switching Capacity	128 Gbps
MAC Address Table Size	16K
Jumbo Frames	9K Bytes
Operating Humidity	10% to 90% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)
Layer	L2/L3
Forwarding Rate	95.2 Mpps
VLANs	4K
Management	Web, CLI, SNMP
Power Supply	Internal
Dimensions (W x D x H)	440 x 44 x mm
Operating Temperature	0°C
Storage Temperature	-40°C to 70°C
Ports	24 x 1G SFP ports, 4 x 10G SFP+ ports