C
HAPTER
42
| DHCP Commands
DHCP Server
– 991 –
netbios-node-type This command configures the NetBIOS node type for Microsoft DHCP
clients. Use the no form to remove the NetBIOS node type.
SYNTAX
netbios-node-type type
no netbios-node-type
type - Specifies the NetBIOS node type:
broadcast
hybrid (recommended)
mixed
peer-to-peer
DEFAULT SETTING
None
COMMAND MODE
DHCP Pool Configuration
EXAMPLE
Console(config-dhcp)#netbios-node-type hybrid
Console(config-dhcp)#
RELATED COMMANDS
netbios-name-server (990)
network This command configures the subnet number and mask for a DHCP address
pool. Use the no form to remove the subnet number and mask.
SYNTAX
network network-number [mask]
no network
network-number - The IP address of the DHCP address pool.
mask - The bit combination that identifies the network (or subnet)
and the host portion of the DHCP address pool.
COMMAND MODE
DHCP Pool Configuration
USAGE GUIDELINES
â—† When a client request is received, the switch first checks for a network
address pool matching the gateway where the request originated (i.e.,
if the request was forwarded by a relay server). If there is no gateway
in the client request (i.e., the request was not forwarded by a relay
To Next Page
Loading...
Need help?
General
