1 - 4
Chapter 1 Service Call Procedure
1.1.3 Other Things to Note
Pay attention to the following when performing maintenance service to avoid wrong or redundant
servicing:
1. Reference Materials
Before performing maintenance servicing, read all relevant technical materials such as SB, FTI,
or FTO for a systematic approach.
2. Disassembling
Make sure to check the assembled condition before removing parts or disassembling the
machine.
3. Installation/Adjustment
After the installation or adjustment is complete, check that no parts or tools are left inside or on
the assemblies before using the machine.
4. Handling of parts/consumables replaced
Make sure that the replaced parts or consumables as well as the packaging materials are
collected back to the Service Center.
For the separation and processing methods for the collected items, refer to the
Common Technical Information No. 2-138 for all machines.
If you have replaced the following consumables, affix the "U" sticker for the recyclable parts to be
handled appropriately.
• Drum Cartridge
• Individual Color Toner Cartridge
For recyclable parts, fill the necessary items in the "U-TAG" and perform collection.
5. General precautions
• Take care not to disturb the customer's daily work.
• Place the drip cloth or paper on the customer's floor during work in the machine because
color toners may dirty the floor and are difficult to clean.
• Throw any trash generated during the maintenance service into the trash bag and bring them
to the servicing office.
• Record the service details and the consumables and parts replaced at visit in the Machine
Service Log.
DocuPrint CM305 df weighs 29.6kg.
Always have 2 or more people available to move the printer.
Refer to the Installation Procedures for details.
To Next Page
Loading...
Need help?
General
