Fuji Xerox DocuPrint CM305 df - FIP-1.P1 the Output Is too Light; FIP-1.P2 the Entire Output Is Blank; FIP-1.P3 Part or the Entire Output Is Black

3 - 3
Chapter 3 Image Quality Troubleshooting
When an image quality problem occurs, output a sample print to grasp the nature of the problem,
and then perform troubleshooting using "Image Quality FIP List".
If the problem persists even after a troubleshooting with the Image Quality FIP, check using the FIP
again, and then replace the Possible causative parts listed in the relevant FIP one by one. Image
Quality FIP List
-FIP-1.P1 The output is too light
-FIP-1.P2 The entire output is blank
-FIP-1.P3 Part or the entire output is black.
-FIP-1.P4 Toner smears
-FIP-1.P5 Random spots
-FIP-1.P6 Streaks appear on the output
-FIP-1.P7 Pitched color dots
-FIP-1.P8 Vertical blanks
-FIP-1.P9 Ghosting
-FIP-1.P10 Light-Induced Fatigue
-FIP-1.P11 Fog
-FIP-1.P12 Bead-Carry-Out (BCO)
-FIP-1.P13 Jagged characters
-FIP-1.P14 Banding/Horizontal band cross out
-FIP-1.P15 Auger mark
-FIP-1.P16 Wrinkled/Stained paper (Envelope Wrinkle)
-FIP-1.P17 The top margin is incorrect / The side margin is incorrect
-FIP-1.P18 Color registration is out of alignment
-FIP-1.P19Images are skewed
-FIP-1.P20 Paper Damage
-FIP-1.P21 Unfusing
-FIP-1.P22 Label Stuck