4 - 66
Chapter 4 Disassembly / Assembly and Adjustments
REP3. PAPER FEEDER
REP3.1 (SCC) CLUTCH ASSY DRV (PL3.1.1), BEARING REGI (PL3.1.2)
[Removal]
1) Remove the CASSETTE ASSY 250 MG AIO. (REP2.1)
2) Open the COVER ASSY FRONT (PL1.2.1).
Cover the drum of the PHD ASSY to avoid exposure to light.
3) Remove the PHD ASSY. (REP4.6)
The FUSING UNIT part is very hot. Take added care not to get burned when
performing the service operation.
4) Remove the FUSING UNIT. (REP6.1)
5) Remove the COVER ASSY SIDE L AIO. (REP1.9)
When carrying out the work described below, leave the relay connector on the
printer harness side.
6) Release the harness of the CLUTCH
ASSY DRV (PL3.1.1) from the hook
of the DRIVE ASSY PH (PL7.1.4).
7) Disengage the connector (P/J262) of
the CLUTCH ASSY DRV.
To Next Page
Loading...
