6 – 7
Chapter 6 General
6.1.4 Functions
6.1.4.1 Recording System
Tandem electro-photographic system employing OPC drum and direct transfer by the transport belt
6.1.4.2 Exposure System
Four laser beams semiconductor scanning system
6.1.4.3 Development System
Development with dry type 2-component developer
6.1.4.4 Fixing System
Thermal fixing system
6.1.4.5 Resolution
600 dpi x 600 dpi
6.1.4.6 Operation Mode
The printer can be operated in either of 5 operation modes. The modes are switched over by command
from the printer controller or change of printer operation, etc.
Proceeding from power ON, low power mode or sleep mode to standby mode will take place after going
through a warm up stage.
- Running mode (Printing)
State in running or recording operation
Fixing system: Held at operating temperature.
Exposure system: Operating status
Recording system: Operating status
- Running mode (Scanning)
Exposure system: Operating status
- Ready mode
Ready state
Fixing system: Held at ready temperature.
Exposure system: Stop status
Recording system: Stop status
- Sleep mode
Complete resting state. Compatible to E-Star requirement.
Fixing system: Stop status
Exposure system: Stop status
Recording system: Stop status
- Deep sleep mode
Resting state from the sleep state.
Fixing system: Stop status
Exposure system: Stop status
Recording system: Stop status
To Next Page
Loading...
Need help?
General
