Fuji Xerox DocuPrint CM305 df - Warm-Up Time; FPOT (First Print Output Time); Input Properties

6 – 8
Chapter 6 General
6.1.4.7 Warm-up Time
When nominal voltage (110V, 220V) is applied, the printer will proceed to standby mode from POWER-
ON within 16 seconds.
The time from when the "Start" button is pressed after placing a document in the Standby mode until
the trail edge of the first copied sheet passes the IOT exit roll.
6.1.4.8 FPOT (First Print Output Time)
FPOT time of the printer is shown in the table below.
The time required for the first sheet of paper to be delivered after the PRINT indication is given is
calculated on the following conditions (rounded to one decimal place).
• IOT performance that the controller does not have IOT wait.
• The printer is in the standby mode. (ROS MOTOR OFF, FUSING UNIT READY)
• Paper is A4 SEF
• Document on the platen glass or the ADF.
• Except when process control is operating*1
*1:Process controller operation is process controls such as TC control, electric potential control,
cleaning cycle, registration control, and so on. Sometimes, the engine stops feeding papers for
a certain period of time while continuous printing for these operations.
- Color mode
B/W: 21 sec. or less
Color: 30 sec. or less
6.1.4.9 Input Properties
(1) Paper pick-up system
- Paper pick-up with paper tray
Feeding method of this printer is ARRF method.
(2) Paper pick-up capacity
- Paper pick-up with paper tray
• 250 sheet Paper Tray : 250 sheets or below 27.6mm of standard paper
- SSI paper pick-up
1 sheet