4 - 225
Chapter 4 Disassembly / Assembly and Adjustments
19) Release the harness of the HAR-
NESS ASSY FUSING UNIT MG
AIO (PL6.1.2) from the GUIDE
HARNESS FSR AIO (PL8.2.1).
20) Release the boss of the GUIDE
HARNESS FSR AIO, move the
GUIDE HARNESS FSR AIO to
remove it from the printer.
21) Disengage the two connectors (P/J10
and 11) on the PWBA MCU
(PL8.3.6), pull it out from the hole of
the PLATE ASSY TOP.
To Next Page
Loading...
