4 - 275
Chapter 4 Disassembly / Assembly and Adjustments
15) Remove the clamp that fixes the
HARN ASSY ADF (PL10.1.2) from
the printer.
16) Remove the one screw (silver, 6mm)
that fixes the ground wire of the
HARN ASSY ADF. Disengage the
two connectors (P/J1002 and 1003)
on the PWBA ESS AIO (PL8.1.2),
release the harness of the IIT ASSY
SUB from the clamp.
Release the HARN ASSY ADF from
the hook of the HOLDER FFC
(PL8.4.7).
17) Pull out the harness of the IIT ASSY
SUB to outside from the hole of the
frame.
To Next Page
Loading...
